To Next Page

To Previous Page

PowerPanel™ Business Edition

Introduction

PowerPanel

Business Edition (PPBE) software provides comprehensive advanced power management

for UPS systems. It controls unattended shutdowns, scheduled shutdowns, and notifications for computers

PowerPanel

Business Edition software consists of Agent and Client. The Agent serves to monitor and

configure the UPS through the USB or serial connection. It logs the UPS status and power events, and

generates action in response to event. The Client establishes the communication with the Agent or directly to

UPS RMCARD and PDU, and generates actions according to the notification from the UPS/PDU when a

power event occurs.

Users can install the Agent on a single computer connected to the UPS with a USB or serial connection. The

Agent controls the UPS and establishes communication with the Client if the UPS has no remote

management card. The Agent relays the UPS state to each Client and the Client performs actions based on

the notifications. Each computer powered by the UPS can be protected and controlled using the Client

application. In the event of power failure, the Agent will shut down the hosted computer and request the

Client computers to shut down prior to the UPS shutdown. Refer to Configuration A of the PowerPanel

Business Edition structure illustration.

The UPS with a remote management card has the ability to communicate with multiple computers which

had installed Client on the network and relay the UPS status to each Client. In the event of a power failure,

Each Client will request the hosted computer to shut down following notifications from the UPS. Refer to

Configuration B of the PowerPanel

Business Edition structure illustration.

PowerPanel

Business Edition structure

Agent

CyberPower PowerPanel User Manual

Other manuals for CyberPower PowerPanel