DIR-842V2 AC1200 Wi-Fi Gigabit Router
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.).
!
For security reasons, DIR-842V2 with default settings cannot connect to the Internet. To
get started, please set your own password used to access the web-based interface
and, if needed, configure other settings recommended by your ISP.
Start a web browser (see the Before You Begin section, page 20). In the address bar of the web
browser, enter the domain name of the router (by default, dlinkrouter.local) with a dot at
the end and press the Enter key. Also you can enter the IP address of the device (by default,
192.168.0.1).
Figure 22. Connecting to the web-based interface of the DIR-842V2 device.
!
If the error “The page cannot be displayed” (or “Unable to display the page”/“Could not
connect to remote server”) occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Setup Wizard opens (see the Setup Wizard section, page 48).
Figure 23. The page for running the Setup Wizard.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
