50D-Link DCS-2332L User Manual
Section 4: Conguration
Enable UPnP presentation:
Enable UPnP port forwarding:
Enable PPPoE:
User Name / Password:
HTTP Port:
Access Name for Stream 1~3:
HTTPS Port:
Authentication:
RTSP Port:
Access name for stream 1 ~ 3:
Enabling this setting allows your camera to be congured
as a UPnP device on your network.
Enabling this setting allows the camera to add port
forwarding entries into the router automatically on a
UPnP capable network.
Enable this setting if your network uses PPPoE.
Enter the user name and password for your PPPoE
account. Re-enter your password in the Conrm Password
eld. You may obtain this information from your ISP.
The default port number is 80.
The default name is video#.mjpg, where # is the number
of the stream.
You may use a PC with a secure browser to connect to
the HTTPS port of the camera. The default port number
is 443.
Depending on your network security requirements, the Network Camera provides two types of security
settingsforstreamingviaRTSP protocol: Disable and Digest. If Digestauthenticationisselected,usercredentials
areencryptedusingMD5 algorithm, thus providing better protection against unauthorized access.
The port number that you use for RTSP streaming to mobile devices, such as mobile phones or PDAs. The
default port number is 554. You may specify the address of a particular stream. For instance, live1.sdp can be
accessed at rtsp://x.x.x.x/video1.sdp where the x.x.x.x represents the IP address of your camera.
This Network Camera supports multiple streams simultaneously. The access name is used to dierentiate the
streaming source (video prole).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
