D-Link DES-1005E User Manual

ENGLISH
16
Networking Basics
Check your IP address
After you install your new D-Link adapter or if you already have an Ethernet adapter installed on your computer, by default, the TCP/IP settings
should be set to obtain an IP address from a DHCP server (i.e. router) automatically. To verify your IP address, please follow the steps below.
• ClickonStart > Run. In the run box type cmd and click OK. (Windows® 7 and Vista® users type cmd in the Start Search box.)
• Attheprompt,typeipcong and press Enter.
• ThiswilldisplaytheIPaddress,subnetmask,andthedefaultgatewayofyouradapter.

D-Link DES-1005E Specifications

Data Transfer Rates

Ethernet data transfer rate (half duplex)	10 Mbps
Ethernet data transfer rate (full duplex)	20 Mbps
Fast Ethernet data transfer rate (half duplex)	100 Mbps
Fast Ethernet data transfer rate (full duplex)	200 Mbps

Power

external power adapter	5V/1.2A
power consumption (standby, DC input)	0.6 watts
power consumption (standby, AC input)	1.4 watts
power consumption (maximum, DC input)	3.3 watts
power consumption (maximum, AC input)	5.2 watts

Heat Dissipation

heat dissipation (standby, AC input)	6.138 BTU/h
heat dissipation (maximum, AC input)	12.958 BTU/h

Operating Environment

operating temperature	0 to 50 ˚C (32 to 122 ˚F)
storage temperature	-10 to 70 ˚C (14 to 158 ˚F)
operating humidity	10% to 90% RH Non-Condensing
storage humidity	5% to 90% RH Non-Condensing

Weight and Dimensions

dimensions (W x D x H)	5.0” x 3.3” x 1.2” (125.3 x 83.4 x 29.1 mm)