D-Link DES-1008E User Manual

ENGLISH
6
Static electricity can harm delicate components inside your system. To prevent static damage, discharge static electricity from your body before
you touch any of the electronic components, such as the microprocessor. You can do so by periodically touching an unpainted metal surface on
the chassis.
You can also take the following steps to prevent damage from electrostatic discharge (ESD):
1. When unpacking a static-sensitive component from its shipping carton, do not remove the component from the antistatic packing
material until you are ready to install the component in your system. Just before unwrapping the antistatic packaging, be sure to
discharge static electricity from your body.
2. When transporting a sensitive component, rst place it in an antistatic container or packaging.
3. Handle all sensitive components in a static-safe area. If possible, use antistatic oor pads, workbench pads, and an antistatic
grounding strap.
Protecting Against Electrostatic Discharge

D-Link DES-1008E Specifications

Data Transfer

switching fabric	1.6 Gbps
data transfer rate (Ethernet, half duplex)	10 Mbps
data transfer rate (Ethernet, full duplex)	20 Mbps
data transfer rate (Fast Ethernet, half duplex)	100 Mbps
data transfer rate (Fast Ethernet, full duplex)	200 Mbps

Power

DC input	5V/1.2A
power consumption (standby, DC input)	0.6 watts
power consumption (standby, AC input)	1.4 watts
power consumption (maximum, DC input)	3.3 watts
power consumption (maximum, AC input)	5.2 watts

Operating Environment

operating temperature	32 to 122 ˚F (0 to 50 ˚c)
storage temperature	14 to 158 ˚F (-10 to 70 ˚c)
operating humidity	10% to 90% RH Non-Condensing
storage humidity	5% to 90% RH Non-Condensing

Heat Dissipation

heat dissipation (standby, AC input)	4.774 BTU/h
heat dissipation (maximum, AC input)	17.732 BTU/h

Weight and Dimensions

device dimensions (W x D x H)	6.5” x 4.4” x 1.5” (164.5 x 111.5 x 36.0 mm)