6. WHITE BALANCE Adjusting Method
-29-
To adjust WHITE BALANCE, refer to below process.
6-1. Insert white pattern to component input
Signal Generator : 802BT (By Quantum Data)
Resolution : 1280x720p @60Hz,
Pattern : Grey Scale (11 step)
6-2. Confirm ‘dimming’ in service mode (=s10)
32C3 = 0, 26C3 = 255
6-3. Attach white balance meter(CA-210) on center of Panel
6-4. Press the service key s8
6-5. Adjust white balance with valiable R.G.B cutoff / drive.
Color coordinates
X = 0.280 0.01, Y = 0.285 0.01, cd/m2 = 50cd/m2
X = 0.280 0.01, Y = 0.290 0.01, cd/m2 = 300cd/m2
6-6. Press s8 buttorn to escape SERVICE MODE
The difference of LCD Panel is not so much, therefore we don’t adjust white balance.
To Next Page
Loading...
Need help?
General
