Instruction Si12-411A
150 System Configuration
1. Open the front grille.
2. Pull out the air filters.
•
Push a little upwards the tab at the center of each air
filter, then pull it down.
3. Take off the air purifying filter,
photocatalytic deodorizing filter.
•
Hold the recessed parts of the frame and
unhook the four claws.
4. Clean or replace each filter.
See below.
5. Set the air filter, air purifying filter
and photocatalytic deodorizing filter as
they were and close the front grille.
•
Insert claws of the filters into slots of the front grille.
Close the front grille slowly and push the grille at the 3
points. (1 on each sides and 1 in the middle.)
■
Air Filter
1. Wash the air filters with water or clean them with
vacuum cleaner.
•
If the dust does not come off easily, wash them with neutral detergent
thinned with lukewarm water, then dry them up in the shade.
•
It is recommended to clean the air filters every two weeks.
■
Air Purifying Filter (green)
(Replace approximately once every 3 months.)
1. Detach the filter element and attach a new one.
•
Insert with the green side up.
•
It is recommended to replace the air purifying filter every three months.
■
Photocatalytic Deodorizing Filter (gray)
[ Maintenance ]
1. Dry the photocatalytic deodorizing filter in the sun.
•
After removing the dust with a vacuum cleaner, place the filter in the sun for approximately 6 hours.
By drying the photocatalytic deodorizing filter in the sun, its deodorizing and antibacterial capabilities
are regenerated.
•
Because the filter material is paper, it can not be cleaned with water.
•
It is recommended dry the filter once every 6 months.
[ Replacement]
1. Detach the filter element and attach a new one.
Filters
Air filter
Air purifying
filter or
photocatalytic
deodorizing
filter
Push
To Next Page
Loading...
Need help?
General
