Daikin RCS 20F User Manual

Wiring Diagrams
Figure 23: Typical Wiring Schematic - RCS 06G – 07G
MATERIAL: PRINTING INSTRUCTIONS:
NO REVISION TO DESIGN, MATERIAL, TOOLING, OR PROCESS IS ACCEPTABLE WITHOUT PRIOR APPROVAL FROM RHEEM THROUGH AN AUTHORIZED CHANGE NOTICE, A REVISED ENGINEERING SPECIFICATION AND A RESAMPLING OF PARTS. THE SUPPLIER IS RESPONSIBLE FOR NOTIFYING RHEEM R & D AND PURCHASING DEPARTMENTS IN WRITING OF ANY CHANGES AFFECTING PRODUCT QUALITY, PERFORMANCE, RELIABILITY, PACKAGING, DELIVERY OR WORKMANSHIP. “ANY DOCUMENTSREFERRED TO ON THIS DRAWING ARE INCLUDED IN THE SPECIFICATIONS FOR THIS COMPONENT”.
NOTES
COMPONENT CODES
WIRE COLOR CODE
BK......BLACK BR......BROWN BL.......BLUE
G........GREEN GY......GRAY O........ORANGE
PR......PURPLE R........RED W.......WHITE Y........YELLOW
ORIGINAL RELEASE NO.:
ELECTRICAL WIRING DIAGRAM
CONDENSING UNITS
MODELED BY:
CHECKED:APPROVED:
REV:PART NO.:
DATE:
ADS-4574-10, PRESSURE SENSITIVE, ADHESIVE BACKED MATERIAL
MAKE EXACTLY
12.0 IN X 4.125 IN. WHITE BACKGROUND WITH BLACK PRINTING
WIRING INFORMATION
WARNING -CABINET MUST BE PERMANENTLY GROUNDED AND CONFORM TO I.E.C., N.E.C., C.E.C., NATIONAL WIRING REGULATIONS, AND LOCAL CODES AS APPLICABLE.
REPLACEMENT WIRE -MUST BE THE SAME SIZE AND TYPE OF INSULATION AS ORIGINAL (105C. MIN.) -FIELD INSTALLED -FACTORY STANDARD LOW VOLTAGE -FIELD INSTALLED -FACTORY OPTION -FACTORY STANDARD LINE VOLTAGE
90-101229-47
TEW 06-09-17
REV.:MODELED BY: PART NO.:DATE:
90-101229-47
TEW 06-09-17
05
THE DOTTED BOX NEAR THE DRAWING NUMBER REPRESENTS A .25 X.25 2D DATA MATRIX. SEE ADS-104669-01 FOR DATA MATRIX SPECS.
NOTE:
Y
(T1)
(T2)
(T3)
AUX
CT
R
BK
BK/R
O
Y BR R
05
CT
BK
GND
G/Y
GND
OPT.
G/Y
CCH
BK
BK
BK
BR
BL
(BK) (BK) (BK)
(1T1)
(1T2)
(1T3)
OPT
AUX.
Y
YY
Y Y
Y
Y
BR
BR
WIRING DIAGRAM WIRING SCHEMATIC
GRD.
LUG
GND
(OPT)
HPC
LPC
HGS
LAC
(OPT)
(OPT)
(OPT)
TDC
R2 R1 Y1 Y2
(OPT)
OFM
COMP
T1
T2
T3
CC
L1
L2
L3
Y
BR R
AUX
CC
CCH
CT
COMP
GND
HGS
HPC
LAC LPC
OFM
OPT
RES
SC
SR
TDC
AUXILIARY CONTACT COMPRESSOR CONTACTOR CRANKCASE HEATER CONTROL TRANSFORMER COMPRESSOR GROUND CHASSIS HOT GAS SENSOR HIGH PRESSURE CONTROL LOW AMBIENT COOLING CONTROL LOW PRESSURE CONTROL OUTDOOR FAN MOTOR OPTIONAL COMPONENT RESISTOR START CAPACITOR START RELAY TIME DELAY CONTROL
1. CONNECTORS SUITABLE FOR USE WITH COPPER CONDUCTORS ONLY. 2. COMPRESSOR MOTOR THERMALLY PROTECTED AND ALL 3 PHASE ARE PROTECTED UNDER PRIMARY SINGLE PHASE CONDITIONS. 3. CONNECT FIELD WIRING IN GROUNDED RAINTIGHT CONDUIT TO FUSED DISCONNECT VOLTAGE, HERTX, AND PHASE PER RATING PLATE. 4. LOW VOLTAGE CIRCUIT TO BE N.E.C. CLASS 2 WITH A CLASS 2 TRANSFORMER 24 VOLT, 50 OR 60 HERTZ. 5. TO THERMOSTAT SUB-BASE, REFER TO SYSTEM SCHEMATICS OR SCHEMATICS ON INDOOR SECTION FOR LOW VOLTAGE CONTROL WIRING. 6. MAIN UNIT TRANSFORMER PRIMARY LEADS: 208/230-460V 60HZ: BLACK-COM, RED - 208V, ORANGE - 230V, BLACK/RED - 460V 220/240V 50HZ: BLACK-COM, RED - 220V, ORANGE - 230V 380V 60HZ: ORANGE-COM, BLUE - 380V
A-1093S000
208/230, 380, 460V, 3 PH, 60 Hz,
220/220, 380/415V, 3 PH, 50 Hz
04
REVISED WIRE ID CC TO COMP, 1T1 WAS T1, 1T2 WAS T2 AND 1T3 WAS T3.
GND
TEW
A-1093S007
11-14-17
BL
Y
05
ADDED NOTE 6. REVISED TITLE BLOCK TO INCLUDE ALL VOLTAGES FOR 50HZ AND 60HZ.
TEW
A-1093S010
12-15-17
BK
BK
03
ADDED WIRE NUTS TO OPTIONAL WIRING CC TO CCH.
TEW
A-1093S005
11-03-17
SEE NOTE 6

www.DaikinApplied.com 27 IM 962-4 • AIR-COOLED SPLIT SYSTEM CONDENSERS

Daikin RCS 20F Specifications

General

Brand	Daikin
Model	RCS 20F
Category	Heat Pump
Language	English