SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series SiBE121021_C
276 Operation Manual
7 English
VRV System
Refer to figure 1 on page [1]
Operate in the following order.
Refer to figure 1-1, 2 on page [1]
5. OPERATION PROCEDURE
1
ON/OFF
Press ON/OFF button
NOTE
Refer to figure 1-1,3 on page [1]
2
1
The setting temperature range of the remote
controller is 16°C to 32°C.
See the operation manual provided with the
air conditioner.
• Operating procedure varies with heat
pump type and cooling only type. Contact
your Daikin dealer to confirm your system
type.
• To protect the unit, turn on the main power
switch 6 hours before operation.
• If the main power supply is turned off
during operation, operation will restart
automatically after the power turns back
on again.
COOLING, HEATING, AUTOMATIC,
FAN, AND PROGRAM DRY
OPERATION
• AUTOMATIC OPERATION can be
selected only by Heat pump split system.
• For cooling only type, “COOLING”, and
“FAN” and “DRY”operation are able to
select.
〈〈FOR SYSTEMS WITHOUT COOL/
HEAT CHANGEOVER REMOTE
CONTROL SWITCH〉〉
OPERATION MODE
SELECTOR
Press OPERATION MODE SELECTOR
button several times and select the
OPERATION MODE of your choice as
follows.
• The function of this program is to
decrease the humidity in your room with
the minimum temperature decrease.
• Micro computer automatically
determines TEMPERATURE and FAN
SPEED.
• This system does not go into operation if
the room temperature is below 16˚C.
OPERATION lamp lights up or goes off and
the system starts or stops OPERATION.
• Do not turn OFF power immediately after
the unit stops. Then, wait no less than 5
minutes.
Water is leaking or there is something else
wrong with the unit.
〈〈FOR SYSTEMS WITH COOL/HEAT
CHANGEOVER REMOTE CONTROL
SWITCH〉〉
OPERATION MODE
SELECTOR
(1) Select OPERATION MODE with the
COOL/HEAT CHANGEOVER REMOTE
CONTROL SWITCH as follows.
COOLING OPERATION................... “ ”
HEATING OPERATION.................... “ ”
COOLING OPERATION ............ “ ”
HEATING OPERATION............. “ ”
AUTOMATIC OPERATION................“ ”
• In this operation mode, COOL/HEAT
changeover is automatically conducted.
FAN OPERATION............................. “ ”
DRY OPERATION .............................“ ”
To Next Page
Loading...
Need help?
General
