Configuring the ECL 2000
EY.65.H4.02
28
To exit a configuration picture:
5. Press
until the arrow symbol at the top right corner reappears.
6. Use
or to access other configuration pictures.
See also page 29.
Configuring LON
Inputs
A maximum of 4 sensors can be configured as input from the LON network. To ac-
cess LON configuration pictures:
1. Press
in the last sensor input picture (Input S9 for the ECL 2000 Type
1 and Input S11 for the Type 2).
X
2. Use
to select the different parameters.
3. Use
to modify the parameters Sensor, Circuit and Unit.
4. Use
and to modify the parameter Poll.
Section 8.4.3 starting on page 32 gives some details about the possible settings of the
LON inputs. See also section 10.4.6 on page 70 for information on the LON address.
Configuring the Relay
Output
Some ECL 2000 applications allow you to change the function of the relay output P3.
When this is possible, you can access the Output P3 picture by pressing
in either
the last sensor picture (Input S9 or Input S11) or, if the LON option is installed, in the
Input L4 picture. This is illustrated below. Section 8.4.3 starting on page 32 gives
details about the possible settings of P3.
1. Use to select the parameter Function.
2. Use
to modify the setting.
To Next Page
Loading...
Need help?
General
