Danfoss MCD 600 User Manual

2 Installation
2.1 Installing the Expansion Card
Procedure
1. Push a small flat-bladed screwdriver into the slot in the center of the expansion port cover and ease the cover away from the soft
starter.
2. Line up the card with the expansion port.
3. Gently push the card along the guide rails until it clicks into the soft starter.
Example:
1 2
e77ha739.10
Illustration 1: Installation of the Expansion Cards
2.2 Connecting to the Network
Prerequisites:
The expansion card must be installed in the soft starter.
Procedure
1. Restore control power.
2. Connect field wiring via the DB9 plug.
Example:
Table 1: DB9 Connector
Pin number Assignment
1 Shield
2 24 V DC negative (optional)
Installation
Installation Guide | PROFIBUS Card
AQ277154583779en-000101 / 175R1181 | 5
Danfoss A/S © 2018.09

Danfoss MCD 600 Specifications

General

Brand	Danfoss
Model	MCD 600
Category	Controller
Language	English