Pin number Assignment
3 RxD/TxD-P
4 Not used
5 DGND
6 VP (end of bus slave only)
7 24 V DC positive (optional)
8 RxD/TxD/-N
9 DGND
2.3 Feedback LEDs
Off On
Power (red) Device is not powered up. Device is powered up and ready to go online.
Network (green) No connection, offline or data exchange failure. Device is online and in data exchange state.
NOTICE
If communication is inactive, the soft starter may trip on Network Communications. If parameter 6-13 Network Communications is
set to Soft Trip and Log or Trip Starter, the soft starter requires a reset.
NOTICE
If communication fails between the device and the network, the Bus Status LED goes off. When communication is restored, the
Bus Status LED turns back on.
Installation
Installation Guide | PROFIBUS Card
AQ277154583779en-000101 / 175R1181
6 | Danfoss A/S © 2018.09
To Next Page
Loading...
Need help?
General
