GB
PL
DANFOSS HEATING 23
Changing preset programmes for AB programming
(Installer option 41 must be set to 5-2 day mode)
Press and hold PROG and V for 3 seconds. The
display will change to the fi gure opposite. This
will take you into User Advanced Programming
option 1.
Use Λ and V keys to enable or disable the function
(1=enabled, 0=disabled).
Press PROG for 5 seconds until the display returns
to previous RUN mode.
Press PROG once, the display will change to show
the default days assigned to programme “A” (days
MON, TUE, WED, THU, FRI).
Use the + and - keys to scroll forwards or backwards
through the days of the week.
To deselect a day press V, (for example TUE). To
select a day press Λ (for example SUN).
Any deselected days are automatically assigned to programme “B”.
Programming “A” programme days and events
a) Press PROG until the fi rst preset time and/or temperature (Event 1
for Programme A) appears in display.
b) Use the + and - buttons to adjust the TIME
(press and hold to change in 10 minute
increments).
c) Use the Λ and V buttons to adjust the required TEMPERATURE.
d) Press NEXT to move to the next preset time and temperature (CH
only) (Event 2).
e) Repeat steps b, c, & d to programme the remaining events.
To Next Page
Need help?
General
