MG.20.B6.02 – VLT is a registered Danfoss trademark
49
VLT
®
2000 Series
Section 1 Section 2 Section 3
The groups (modes) (continued)
Parameter group:
You enter Parameter group from either Menu group or
Data group by using the “Menu” key.
In Parameter group you can select the parameter(s)
you want to alter. You change between the various
parameters in the menu by means of the “+” and “−”
keys.
00,0 Hz
00 0 LANGUAGE
ENGLISH 1
Parameter number flashes
0 = Cursor
flashes
Set data value
Parameter name
Data group:
You can only enter Data group from Parameter group
and only by using the “Data” key. In Data group you
can alter the data value of the parameter you have
chosen in Parameter group. You switch between the
different data values by means of the “+” and “−”
keys.
If the VLT frequency converter is in Data group for more
than 20 sec. and if no activity has been registered, you
leave the Data group automatically.
If you have altered a data value, this will not be stored.
Press the “Data” key once to return.
To store the new (selected) data value, you must
leave Data group.
You do this by pressing the “Menu” key, or it takes place
automatically after 20 seconds.
00,0 Hz
LANGUAGE
E NGLISH 1
Parameter name
E = Cursor flashes
Data value
Alarm group:
The VLT frequency converter will enter Alarm group
upon a trip condition.
If TRIP is displayed the operation has stopped
and you must press the “Stop/Reset” key to
reset the VLT. If TRIP LOCKED is displayed you
must switch off the VLT and then switch it on again,
and then press the “Stop/Reset” key.
ALARM
TRIP
OVERVOLTAGE
Reset mode
Reason for alarm
How to operate your VLT
Setup number ( does not change
on change of mode)
Setup number ( does not change
on change of mode).
.
.
■
To Next Page
Loading...
Need help?
General