Danfoss vlt aqua Programming Guide

10-31 Store Data Values
Option: Function:
Parameter values changed via DeviceNet are not automatically
stored in non-volatile memory. Use this parameter to activate a
function that stores parameter values in the EEPROM non-vol-
atile memory, so changed parameter values will be retained at
power-down.
[0]
*
Off Deactivates the non-volatile storage function.
[1] Store edit setup Stores all parameter values from the active set-up in the non-
volatile memory. The selection returns to Off [0] when all values
have been stored.
[2] Store all setups store all parameter values for all set-ups in the non-volatile
memory. The selection returns to
Off [0] when all parameter
values have been stored.
10-32 Devicenet Revision
Range: Function:
0
*
[0 - 65535] View the DeviceNet revision number. This parameter is used for
EDS file creation.
10-33 Store Always
Option: Function:
[0]
*
Off Deactivates non-volatile storage of data.
[1] On Stores parameter data received via DeviceNet in EEPROM non-
volatile memory as default.
10-39 Devicenet F Parameters
Array [1000]
No LCP access
0 *
[0 - 0] This parameter is used to configure the frequency converter via
DeviceNet and build the EDS-file.
2.12. Main Menu - Smart Logic - Group 13
2.12.1. 13-** Prog. Features
Smart Logic Control (SLC) is essentially a sequence of user defined actions (see par. 13-52 [x])
executed by the SLC when the associated user defined
event (see par. 13-51 [x]) is evaluated as
TRUE by the SLC. Events and
actions are each numbered and linked together in pairs. This means
that when
event [0] is fulfilled (attains the value TRUE), action [0] is executed. After this, the
conditions of
event [1] will be evaluated and if evaluated TRUE, action [1] will be executed and
VLT
®
AQUA Drive Programming Guide 2. Parameter Description
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark 131
2

Danfoss vlt aqua Specifications

General

Brand	Danfoss
Model	vlt aqua
Category	DC Drives
Language	English