1.1.10. Changing Data
The procedure for changing data is the same whether you select a parameter in the Quick menu
or the Main menu mode. Press [OK] to change the selected parameter.
The procedure for changing data depends on whether the selected parameter represents a nu-
merical data value or a text value.
1.1.11. Changing a Text Value
If the selected parameter is a text value,
change the text value by means of the up/
down navigation keys.
The up key increases the value, and the down
key decreases the value. Place the cursor on
the value to be saved and press [OK].
13
0
BP0
6
8.10
Illustration 1.11: Display example.
1.1.12. Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric
data value, change the chosen data value by
means of the <> navigation keys as well as
the up/down navigation keys. Use the <>
navigation keys to move the cursor horizon-
tally.
130BP
06
9.10
Illustration 1.12: Display example.
Use the up/down navigation keys to change
the data value. The up key enlarges the data
value, and the down key reduces the data val-
ue. Place the cursor on the value to be saved
and press [OK].
1
3
0B
P070.1
0
Illustration 1.13: Display example.
1.1.13. Changing of Data Value,Step-by-Step
Certain parameters can be changed step by step or infinitely variably. This applies to
Motor Pow-
er
(par. 1-20),
Motor Voltage
(par. 1-22) and
Motor Frequency
(par. 1-23).
The parameters are changed both as a group of numeric data values and as numeric data values
infinitely variably.
1.1.14. Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30 to 15-32 contain a fault log which can be read out. Choose a parameter, press [OK],
and use the up/down navigation keys to scroll through the value log.
1. How to Programme VLT
®
AQUA Drive Programming Guide
20
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
1
To Next Page
Loading...
Need help?
General