3.2.3 Transportation and Unpacking
Before unpacking the adjustable frequency drive, it is recommended to unload it as close as possible to the final installation site.
Remove the box and handle the adjustable frequency drive on the pallet, as long as possible.
NOTE!
The card box cover contains a drilling master for the mounting holes in the D frames. For the E size, please refer to section
Mechanical
Dimensions
later in this chapter.
Figure 3.2: Mounting Template
VLT AQUA High Power Instruction Manual 3 How to Install
MG.20.P3.22 - VLT
®
is a registered Danfoss trademark
3-3
3
To Next Page
Loading...
Need help?
General