Danfoss VLT AutomationDrive FC 300 Series Installation Manual

3.3.6 Terminal Locations for Enclsoure Size F18
Consider the position of the terminals when designing the cable access.
F-frame units have 4 interlocked cabinets:
•
Input options cabinet (not optional for LHD)
•
Filter cabinet
•
Rectier cabinet
•
Inverter cabinet
See chapter 1.3.3 Exploded View Drawings for exploded views of each cabinet. Mains inputs are located in the input option
cabinet, which conducts power to the rectier via interconnecting bus bars. Output from the unit is from the inverter
cabinet. No connection terminals are located in the rectier cabinet. Interconnecting bus bars are not shown.
1 2 3
4
0.0[0.00]
76.4[3.01]
128.4[5.05] 119.0[4.69] 171.0[6.73]
294.6[11.60] 344.0[13.54]
3639[14.33]
438.9[17.28]
75.3[2.96]
150.3[5.92] 154.0[6.06]
219.6[18.65]
0.0[0.00]
244.4[9.62]
244.4[1.75]
939.0[36.97]
1031.4[40.61]
0.0[0.00]
134.6[5.30]
130BA851.12
0.0[1.75]
1 Right side cut-away 3 Left side cut-away
2 Front view 4 Ground bar
Figure 3.15 Input Option Cabinet, Enclosure Size F18 - Fuses Only
The gland plate is 42 mm below the 0 level. Shown are the left side view, front, and right.
Installation Installation Manual
MG37A322 Danfoss A/S © Rev. 04/2015 All rights reserved. 31
3 3

Danfoss VLT AutomationDrive FC 300 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300 Series
Category	DC Drives
Language	English