Danfoss VLT AutomationDrive FC 300 Series Installation Manual

130BA150.10
9 - 10 mm
(0.37 in)
Figure 4.9 Length to Strip the Insulation
2. Insert a screwdriver (max. 0.016x0.1 in [0.4x2.5
mm]) in the square hole.
3. Insert the cable in the adjacent circular hole.
130BT312.10
Figure 4.10 Inserting the Cable in the Terminal Block
4. Remove the screwdriver. The cable is now
mounted in the terminal.
To remove the cable from the terminal:
1. Insert a screwdriver (max. 0.016x0.1 in [0.4x2.5
mm]) in the square hole.
2. Pull out the cable.
130BT311.10
Figure 4.11 Removing the Screwdriver after Cable Insertion
130BT306.10
Figure 4.12 Control Terminal Locations
Electrical Installation
VLT
®
AutomationDrive FC 302 Low Harmonic Drive
132–630 kW
44 Danfoss A/S © Rev. 04/2015 All rights reserved. MG37A322
44

Danfoss VLT AutomationDrive FC 300 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300 Series
Category	DC Drives
Language	English