Contents
1 How to Read this Instruction Manual
1-1
Approvals 1-2
Symbols 1-2
Abbreviations 1-3
2 Safety Instructions and General Warning
2-1
High Voltage 2-1
Safe Stop of FC 300 2-4
IT Line Power 2-9
3 How to Install
3-1
Mechanical Installation 3-5
Electrical Installation 3-7
Power and Control Wiring for Non-shielded Cables 3-8
Connection to Line Power and Grounding 3-9
Motor Connection 3-13
Fuses 3-16
Electrical Installation, Control Terminals 3-21
Connection Examples 3-22
Electrical Installation, Control Cables 3-24
Switches S201, S202, and S801 3-26
Final Set-Up and Test 3-27
Additional Connections 3-29
Mechanical Brake Control 3-29
Motor Thermal Protection 3-30
How to Connect a PC to the Adjustable Frequency Drive 3-30
The FC 300 PC software 3-30
4 How to Program
4-1
The Graphical and Numerical LCP 4-1
How to Program on the Graphical LCP 4-1
How to Program on the Numerical Local Control Panel 4-1
Quick Set-up 4-3
Basic Set-up Parameters 4-7
Parameter Lists 4-30
5 General Specifications
5-1
VLT
®
AutomationDrive FC 300 Instruction
Manual
Contents
MG.33.AG.22 - VLT
®
is a registered Danfoss trademark