Danfoss VLT AutomationDrive FC 300 Instruction Manual

3How to Install
3.1.1 About How to Install
This chapter covers mechanical and electrical installations to and from power terminals and control card terminals.
Electrical installation of
options is described in the relevant Instruction Manual and Design Guide.
Read the safety instructions before installing the unit.
Figure 3.1: Diagram showing basic installation including line
power, motor, start/stop key, and potentiometer for speed
adjustment.
3.1.2 Checklist
When unpacking the adjustable frequency drive, make sure that the unit is undamaged and complete.
For power ratings, please see the Mechanical Dimensions table on the next page.
A selection of screwdrivers (phillips or cross-thread screwdriver and torx), a side-cutter, drill and knife is also recommended to have handy for unpacking
and mounting the adjustable frequency drive. The packaging for these enclosures contains, as shown: Accessories bag(s), documentation and the unit.
Depending on options fitted, there may be one or two bags and one or more booklets.
VLT
®
AutomationDrive FC 300 Instruction
Manual
3 How to Install
MG.33.AG.22 - VLT
®
is a registered Danfoss trademark 3-1
3

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English