Danfoss VLT AutomationDrive FC 303 User Manual

Enclosure A1-A5 B1-B4 C1, C3 C2, C4
a/b (in [mm]) 3.94 [100] 7.87 [200] 7.87 [200] 8.86 [225]
Table 2.1 Minimum Airflow Clearance Requirements
2.3.2 Lifting
•
Check the weight of the unit to determine a safe
lifting method
•
Ensure that the lifting device is suitable for the
task
•
If necessary, plan for a hoist, crane, or forklift with
the appropriate rating to move the unit
•
For lifting, use hoist rings on the unit, when
provided
2.3.3
Mounting
•
Mount the unit vertically
•
The Adjustable frequency drive allows side by
side installation.
•
Ensure that the strength of the mounting location
will support the unit weight.
•
Mount the unit to a solid flat surface or to the
optional backplate to provide cooling airflow (see
Figure 2.2 and Figure 2.3).
•
Improper mounting can result in overheating and
reduced performance.
•
Use the slotted mounting holes on the unit for
wall mounting, when provided.
130BA219.10
A
Figure 2.2 Proper Mounting with Backplate
Item A is a backplate properly installed for required airflow
to cool the unit.
130BA228.10
A
Figure 2.3 Proper Mounting with Railings
NOTE!
Backplate is needed when mounted on railings.
2.3.4 Tightening Torques
See 10.4.1 Connection Tightening Torques for proper
tightening specifications.
Installation
VLT
®
AutomationDrive Instruction
Manual
2-2 MG.33.AI.22 - VLT
®
is a registered Danfoss trademark
2
2

Danfoss VLT AutomationDrive FC 303 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 303
Category	DC Drives
Language	English