Danfoss VLT MCD 201 User Manual

Danfoss Drives · DKDD.PB.551.A1.02 | 51
This is achieved using the MCD USB Module
(Cat. No: 175G9009).
Notes
• A single USB Module is required for each MCD 500
• The USB Module acts as a physical interface when using PC based
Master software such as WinMaster V4.x or MCT 10
• Driver software must be installed before the USB Module can be
used (supplied with the module on CD-ROM).
• For more information on the MCD USB Module, refer to the
Installation Instructions (MI.17.Cx.02) located at www.danfoss.
com/drives
MCD 500 USB Option
MCD500
MCD
USB
Module
PC
Cat. No: 175G9009
USB cable

Danfoss VLT MCD 201 Specifications

General

Brand	Danfoss
Model	VLT MCD 201
Category	Controller
Language	English