Danfoss VLT MCD 201 User Manual

52 | Danfoss Drives · DKDD.PB.551.A1.02
This requires an MCD Serial Interface Module which clips onto the
side of the MCD 200. It is supplied with the MCD Remote Operator
when ordering Cat. No: 175G9004.
Notes
• A single MCD Remote Operator and MCD Serial interface Module
is required for each MCD 200.
• No set-up or conguration is required for operation.
• If two Remote Operators are required, the RS485 Network side
of the rst Remote Operator (terminals B6, B7, B8) must be con-
nected to the RS485 Starter side of the second Remote Operator
(terminals B1, B2, B3). The rst Remote Operator is ordered using
Cat. No: 175G9004 and the second Remote Operator is ordered
using Cat. No: 175G3061.
• The Serial Interface Module is powered by the MCD 200. The
Remote Operator requires an external 18-30 VAC/DC auxiliary
supply.
• For more information on the MCD Remote Operator, refer to the
User Manual (MG.17.Ex.02)) located at www.danfoss.com/drives.
MCD 200 with MCD Remote Operator Option
MCD Remote Operator
RS485
Starter
RS485
Network
B3
B2
B1
-
+
B8
B7
B6
-
+
GND GND
68
61
69
-
+
GND
MCD200
MCD
Serial
Interface
Module
Cat. No: 175G9004

Danfoss VLT MCD 201 Specifications

General

Brand	Danfoss
Model	VLT MCD 201
Category	Controller
Language	English