Linking the Reader
6
POWERSCAN™ PM/PBT9600
LINKING THE READER
Link Datalogic Devices to Base
Before configuring the interface, it is necessary to link the
handheld with the base.
To link the handheld and the base, simply put the hand-
held into the base. If the reader was previously linked to
another base, you must first scan the Unlink bar code
before re-linking it to the new base.
ù0
Unlink
See the Radio Characteristics table on page 25 for the
maximum number of handhelds that can be simultane-
ously linked to a single base station.
Link Scanner as Serial Device to a Bluetooth Host
Use this procedure to let the PowerScan PBT9600 commu-
nicate with a Bluetooth host using the Bluetooth Serial
Port Profile (SPP).
The Battery Status information can
be easily retrieved by double-
tapping with your fingers on top of
the head of the scanner
NOTE: The PowerScan PM/PBT9600 may get warm
during charging: this is normal and does not mean
a malfunction.
NOTE: Before using the battery, read "Battery
Safety" on page 34. Datalogic recommends annual
replacement of rechargeable battery packs to
ensure maximum performance.
To Next Page
Loading...
Need help?
General
