Programming
QUICK REFERENCE GUIDE
17
PROGRAMMING
The reader is factory-configured with a set of standard
default features. Customize your reader using the pro-
gramming bar codes available in the PowerScan™ PM/
PBT9600 Product Reference Guide or using Datalogic
Aladdin software configurator. Check the corresponding
features section for your interface, and also the Data Edit-
ing and Symbologies chapters of the PRG.
Using Programming Bar Codes
This manual contains bar codes which allow you to recon-
figure your reader. Some programming bar code labels,
like the "Reset Default Settings" label below, require only
the scan of that single label to enact the change.
Other bar codes require the reader to be placed in Pro-
gramming Mode prior to scanning them.
Scan an ENTER / EXIT bar code once to enter Programming
Mode; scan the desired parameter settings; scan the
ENTER / EXIT bar code again to accept your changes,
which exits Programming Mode and returns the reader to
normal operation.
Configure Other Settings
Additional programming bar codes are available in the
PRG to allow customization of the programming functions.
If your installation requires different programming than
the standard factory default settings, refer to the PRG.
Resetting Product Defaults
If you aren’t sure what programming options are in your
reader, or you’ve changed some options and want your
custom factory settings restored, scan the bar code below
to reset the reader to initial configuration. See the PRG for
other options, and a listing of standard factory settings.
Reset Default Settings
NOTE: Factory defaults are based on the interface
type. Be sure your reader is configured for the
correct interface before scanning this label.
To Next Page
Loading...
Need help?
General
