Cleaning Procedure
QUICK REFERENCE GUIDE
31
CLEANING PROCEDURE
Proper cleaning is needed on the external plastic surfaces
and output window to guarantee reliable scanning and
charging of the battery.
A regular cleaning routine will remove the dust and dirt
that may accumulate on the product over time. The main-
tenance activity may be repeated more frequently
depending on the severity of the environment in which
the scanner is used.
A periodic deeper cleaning is suggested once per month.
Cleaning plastic surfaces
Exterior surfaces and scan windows exposed to spills,
smudges or debris accumulation require periodic cleaning
to ensure best performance during scanning operations.
Follow the procedures described in this instruction sheet
to keep your PowerScan™ device in good operating condi-
tion.
Common Cleaning Solutions
The cleaners and disinfectants (or their equivalent) listed
below have been tested for use on the PowerScan™ 9600:
WARNING: Be sure to turn off power and unplug
the device from electrical outlet before cleaning.
CAUTION: DO NOT use abrasive pads or cleaning
agents.
PRODUCT CHEMICAL CONTENT
Alcohol Wipes 70% Isopropyl Alcohol
Formula 409® Glass and
Surface Cleaner
n-Alkyl Dimethyl Benzyl Ammonium
Chloride; n-Propoxypropanol
Windex® Multisurface 2-Hexoxyethanol, Butoxypropanol
Clorox® Bleach;
Clorox Healthcare Bleach
Germicidal Cleaner
Diluted to reach max 0.8% of
concentration
Sodium Hypochlorite;
Sodium Hydroxide
Hydrogen Peroxide 3%
100% Gentle dish soap and
water
To Next Page
Loading...
Need help?
General
