Product Reference Guide 279
Chapter 6
References
This section contains explanations and examples of selected bar code features.
See the programming sections for the actual bar code labels used to configure
the reader.
• INTERCHARACTER DELAY
on page 280
• ACK CHARACTER
on page 281
• NAK CHARACTER
on page 282
• ACK NAK TIMEOUT VALUE
on page 283
• ACK NAK RETRY COUNT
on page 284
• DISABLE CHARACTER
on page 285
•
ENABLE CHARACTER
on page 286
KEYBOARD WEDGE
on page 287
• WEDGE QUIET INTERVAL
on page 287
• INTERCHARACTER DELAY
on page 288
•
INTERCODE DELAY
on page 289
DATA EDITING
on page 290
• DATA EDITING OVERVIEW
on page 290
• GLOBAL PREFIX/SUFFIX
on page 291
• GLOBAL AIM ID
on page 292
• LABEL ID: PRE-LOADED SETS
on page 293
• LABEL ID: SET INDIVIDUALLY PER SYMBOLOGY
on page 295
• SET GLOBAL MID LABEL ID CHARACTER(S)
on page 297
•
CHARACTER CONVERSION
on page 297
READING PARAMETERS
on page 299
• LABEL GONE TIMEOUT
on page 299
• GOOD READ LED DURATION
on page 300
• SCAN MODE
on page 301
• SCANNING ACTIVE TIME
on page 302
• FLASH ON TIME
on page 303
• FLASH OFF TIME
on page 304
SYMBOLOGY SETTINGS
on page 305
• DECODING LEVELS
on page 305
•
SET LENGTH
on page 306
•AUTOMATIC CONFIGURATION UPDATE
on page 308
•RF ADDRESS STAMPING
on page 308
•
BT PIN CODE
on page 310
RS-232 PARAMETERS
on page 280
RF FEATURES
on page 308
To Next Page
Loading...
Need help?
General
