Enter/Exit Programming Mode Enable Character
44 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "Enable
Character" on
page 286 for more detailed programming instructions
NOTE
Select Enable Character Setting
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option
Data Bits
on page 31
has been set as 7 Data Bits.
.
$CR2EC
DEFAULT
0x45 = Enable Character is ‘E’
To Next Page
Loading...
Need help?
General
