23
Factory Resets
WARNING! Performing these resets will clear all set filters. Ensure the system’s gain is reduced before performing
these procedures to ensure the system does not go into feedback once the filters are cleared.
Factory Default Reset
This reset option can be found in the PRESET menu and is used to reset all current AFS2 settings back to their factory default
state. Note that this reset will not overwrite presets.
The Factory Default Reset will reset the following parameters back to their factory default state:
• All set AFS filters.
• All parmeters in the AFS OPTIONS menu.
• All parameters in the SYSTEM menu.
To perform a Factory Default Reset:
1� From the Home Screen, press the BACK/MENU button.
2� Turn the DATA wheel to select the PRESET MENU option then press the DATA wheel to advance.
3� Turn the DATA wheel to select the FACTORY DEFAULT option then press the DATA wheel to begin the procedure.
Factory Hard Reset
This reset option involves a boot sequence and can be used to reset all settings (including presets) back to their factory default
state.
The Factory Hard Reset will reset the following parameters back to their factory default state:
• All set AFS filters.
• All parmeters in the AFS OPTIONS menu.
• All parameters in the SYSTEM menu.
• All presets.
To perform a Factory Hard Reset:
1� While powering on the AFS2, press and hold both the CH1 and CH2 BYPASS buttons until the reset confirmation prompt
appears on-screen.
2� Select the YES option with the DATA wheel then press the DATA wheel to confirm the selection and begin the procedure.
Select the NO option or press the MENU/BACK button to abort the procedure.
To Next Page
Loading...
Need help?
General
