DEEP SEA ELECTRONICS DSECONTROL DSE7310 User Manual

DSE Model 7000 Series Control and Instrumentation System Operators Manual
64 Part No. 057-074 7000 Series OPERATING MANUAL ISSUE 2 02/05/2008 ADM
9.1.1 EDITING A PARAMETER
Enter the editor as described above.
Press the (left) or (right) buttons to cycle to the section you wish to view/change.
Press the (up) or (down) buttons to select the parameter you wish to view/change within the
currently selected section.
To edit the parameter, press to enter edit mode. The parameter begins to flash to indicate that you are
editing the value.
Press the (up) or (down) buttons to change the parameter to the required value.
Press to save the value. The parameter ceases flashing to indicate that it has been saved.
To exit the editor at any time, press and hold the button.
NOTE: - When the editor is visible, it is automatically exited after 5 minutes of inactivity to ensure
security.
NOTE: - The PIN number is automatically reset when the editor is exited (manually or automatically) to
ensure security.
NOTE: - More comprehensive module configuration is possible using the 7xxx series PC configuration
software. Please contact us for further details.

DEEP SEA ELECTRONICS DSECONTROL DSE7310 Specifications

General

Brand	DEEP SEA ELECTRONICS
Model	DSECONTROL DSE7310
Category	Control Unit
Language	English