Auto Receive Tel/Fax Available Range: 0–255 seconds Sets the interval at which the printer goes into the fax receive mode
after the external telephone receives an incoming call in 0 to 255
seconds.
Auto Receive
Ans/Fax
Available Range: 0–255 seconds Sets the interval at which the printer goes into the fax mode after the
external answering machine receives an incoming call in 0 to 255
seconds.
Junk Fax Setup On Rejects faxes sent from unwanted numbers by accepting faxes only
from the fax numbers registered in the Phone Book.
Off Does not reject faxes sent from unwanted numbers.
Sent Fax Forward Off Does not forward any of the incoming faxes to a specified destination.
Forward Forwards the incoming faxes to a specified destination.
Print and Forward Prints the incoming fax and forwards it to a specified destination.
Print and E-mail Prints incoming faxes and also forward them to a specified e-mail
address.
Fax Forwarding Number Sets the destination to which incoming faxes will be forwarded.
2 Sided Printing On Prints the received fax on both sides of a sheet of paper.
Off Does not print the received fax on both sides of a sheet of paper.
Remote Receive On Receives a fax by pressing a remote receive code on the external
telephone after picking up the handset of the telephone.
Off Does not receive a fax by pressing a remote receive code on the
external telephone after picking up the handset of the telephone.
Remote Receive
Tone
Available Range: 00–99 Sets the tone to start Remote Receive.
Discard Size Off Prints any excess at the bottom of a fax page without discarding it.
On Discards any excess at the bottom of the page.
Auto Reduction Automatically reduces a fax page to fit it onto the appropriate sized
paper.
Redial Attempts Available Range: 0–13 Sets the number of redial attempts to make when the destination fax
number is busy, within the range of 0 to 13.
Interval of Redial Available Range: 1–15 minutes Sets the interval between redial attempts within the range of 1 to 15
minutes.
Resend Delay Available Range: 3–255 seconds Sets the interval between transmission attempts within the range of 3
to 255 seconds.
Tone / Pulse Tone Sets the dialing type to Tone.
Pulse (10PPS) Sets the dialing type to Pulse (10PPS).
Pulse (20PPS) Sets the dialing type to Pulse (20PPS).
Prefix Dial On Sets a prefix dial number.
Off Does not set a prefix dial number.
Prefix Dial Number Sets a prefix dial number of up to five digits. This number dials
before any auto dial number is started.
Fax Cover Page On Attaches a cover page to faxes.
Fax Header
*1
Off
On
Does not attach a cover page to faxes.
Prints the information of the sender on the header of faxes.
Off Does not print the information of the sender on the header of faxes.
Understanding the Tool Box Menus
209
To Next Page
Loading...
Need help?
General
Weight and Dimensions
