Message Cause Action
The server is down. Check that the server is functioning
normally.
Change the server settings and The printer cannot search for destinations
confirm the server connection. within the specified time.
Increase the time setting for Search Time-
Out on the Dell Printer Configuration Web
Tool. (See "Authentication System" and
"LDAP Server.")
Check that the printer and the server are
properly connected with an Ethernet cable.
If there are not any problems with the
connection and the error persists, the server
settings may have been changed. Consult
your network administrator.
Check the authentication settings. The login name and password for access to Make sure that the correct login name and
an authentication server are incorrect. password are specified in Login Name and
Password on the Dell Printer Configuration
Web Tool. (See "Kerberos Server" and
"LDAP Server.")
Invalid search characters or LDAP The LDAP search filter fails to work properly
Remove special characters, and then search
User Mapping incorrectly configured as special characters are used in your search
again. (See "LDAP User Mapping.")
for Configuration Web Tool. condition or on the LDAP User Mapping
page on the Dell Printer Configuration
Web Tool.
Network connection is not ready. Try
again later.
You have started searching for destinations
before the IP address is set for the printer.
Wait for a while, and then search again.
No attribute or invalid name.
Confirm address info. on server.
The address information on the server
contain incorrect data or are insufficient to
get your search request.
Check the address information registered on
the server or consult your network
administrator.
No Entries. The printer cannot find any destinations
that meet your search condition.
Ta p
OK to return to the Search Network
Address Book screen, and then specify a
new condition to search again.
Search Directory Root incorrectly
configured for Configuration Web
Tool.
The directories that do not exist in the
LDAP server are specified or an invalid DN
syntax is specified.
Make sure that valid values are specified in
Search Directory Root on the Dell Printer
Configuration Web Tool. (See "LDAP
Server.") Specify the origin of the search
with the correct DN syntax, as shown in the
following example:
dc=w2008ad,dc=addressbook,dc=net
Too many search results. Only a The number of search results has exceeded Ta p
Close to display the search results. If
maximum of 50 search scan be the limits (50 search results) the printer can
you cannot find your desired destination on
displayed. Please refine your search if display.
the result list, specify a new condition to
needed.
search again.
Authentication server access Error Some other error occurs regarding the LDAP Turn off the printer, and turn it on again. If
016-530 server address book. the error persists, consult your network
Restart the printer.
administrator.
Understanding Printer Messages
458
To Next Page
Loading...
Need help?
General
Weight and Dimensions
