Dell Dimension 5000 User Manual

5. Remove the Media Card Reader and bracket from its packaging.

6. Ensure that the Media Card Reader is installed before the FlexBay USB cable is connected.

7. Make sure the FlexBay USB cable is connected to the back of the Media Card Reader.

8. Insert the Media Card Reader by sliding and holding the drive latch release downward. Then, slide the drive in to seat it in the computer.

9. Route the USB cable through the cable routing clip.

10. Replace the computer cover.
CD/DVD Drive

Removing a CD/DVD Drive

1. Follow the procedures in "Before you Begin."

2. Remove the computer cover.

3. Remove the drive panel.

4. Disconnect the power and data cables from the back of the drive.
NOTE: Connect the USB cable on the back of the Media Card Reader to the front panel USB connector on the system board.
1
Media Card Reader
2
FlexBay cables
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

Dell Dimension 5000 Specifications

General

Brand	Dell
Model	Dimension 5000
Category	Desktop
Language	English