4. Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5. Press plus (+) or minus (–) to move a selected device up or down the list.
Clearing Forgotten Passwords
1. Follow the procedures in "Before you Begin."
2. Locate the 2-pin password jumper (PSWD) on the system board, and attach the jumper plug to pins 1 and 2 to clear the password.
3. Close the computer cover.
4. Connect your computer and monitor to electrical outlets, and turn them on.
5. After the Microsoft®Windows®desktop appears on your computer, shut down the computer.
6. Turn off the monitor and disconnect it from the electrical outlet.
7. Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system board.
8. Open the computer cover.
9. Locate the 2-pin password jumper (PSWD) on the system board and attach the jumper to pin 1 to reenable the password feature.
10. Close the computer cover.
11. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
1. Follow the procedures in "Before you Begin."
To Next Page
Loading...
Need help?
General