Using Cards 79
Memory Card Blanks
Your computer shipped with a plastic blank installed in the memory card
reader. Blanks protect unused slots from dust and other particles. Save the
blank for use when no media memory card is installed in the slot; blanks from
other computers may not fit your computer.
Remove the blank before installing a media memory card. To remove the
blank, see "Removing a Memory Card or Blank" on page 80.
Installing a Memory Card
You can install a media memory card in the computer while the computer is
running. The computer automatically detects the card.
Memory cards are generally marked with a symbol (such as a triangle or an
arrow) or a label to indicate which end to insert into the slot. The cards are
keyed to prevent incorrect insertion. If card orientation is not clear, see the
documentation that came with the card.
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
To install a memory card:
1
Hold the card with the top side of the card facing up.
2
Slide the card into the slot until the card is completely seated in its
connector.
If you encounter too much resistance, do not force the card. Check the
card orientation and try again.
To Next Page
Loading...
Need help?
General