160 Adding and Replacing Parts
3
Connect the appropriate antenna cables to the
WLAN
card you are
installing:
NOTE: The gray antenna cable may not be available in all computers. The
presence of the gray antenna cable in your Mini Card compartment depends
upon the type of display.
If the WLAN card has two triangles on the label (white and black),
connect the white antenna cable to the connector labeled "main" (white
triangle), and connect the black antenna cable to the connector labeled
"aux" (black triangle).
If the WLAN card has three triangles on the label (white, black, and gray),
connect the white antenna cable to the white triangle, connect the black
antenna cable to the black triangle, and connect the gray antenna cable to
the gray triangle.
4
Secure unused antenna cables in the protective mylar sleeve.
5
Replace the cover and tighten the captive screws.
Removing a Mobile Broadband or WWAN Card
NOTE: WWAN is also available on an ExpressCard (see "Using ExpressCards" on
page 79).
1
Follow the procedures in "Before You Begin" on page 141.
2
Turn the computer over.
3
Loosen the captive screws on the cover of the Mini Card compartment and
remove the cover.
To Next Page
Loading...
Need help?
General