Figure 21. Removing and installing the control panel
1. control panel 2. chassis
3. release tab
Installing the control panel
1. Align the control panel with the slot on the enclosure.
2. Slide the control panel into the enclosure until the release tab clicks into place.
3. Install the hard disk drives in their respective slots. See Installing a hard disk drive.
4. Connect all the power cables to the enclosure.
5. Turn on the enclosure and the host server.
Backplane
WARNING: Whenever you need to lift the enclosure, get others to assist you. To avoid injury, do
not attempt to lift the enclosure by yourself.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Removing the backplane
1. Turn off the enclosure and disconnect it from the electrical outlet.
2. Disconnect all the cables connected to the enclosure.
29
To Next Page
Loading...
Need help?
General