OptiPlex580TechnicalGuidebook Page23
Communications - Integrated LAN
NOTE: MT supports full height card, DT supports low profile card or full height card with optional riser. SFF supports low profile
card.
Integrated Broadcom 5761 Ethernet LAN 10/100/1000 MT DT SFF
External Connector Type RJ45
Data Rates supported 10/100/1000 Mbps
Controller Details
Controller bus architecture (example PCIe 1.0a x1) Intel Gigabit LAN Connect Interface
(GLCI) and LAN Connect Interface (LCI)
Integrated memory N/A
Data transfer mode (example Bus-Master DMA) N/A
Power consumption (full operation per data rate connection speed) 781mW (Max.)
Power consumption (standby operation) with WOL enabled 200mW (Max, 100Mb)
66mW (Max, 10Mb)
Power consumption (standby operation) with WOL disabled in BIOS 0mW (Max)
Power consumption (standby operation) with WOL disabled with driver 47mW (Max)
IEEE standards compliance (example 802.1P) 802.3
Hardware Certifications (example FCC, B, GS mark…) N/A
Boot ROM Support EEPROM (located in SPI)
Network Transfer Mode (example Full Duplex, Half Duplex)
Network Transfer Rate (example 10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
10 Mb (full/half-duplex)
100 Mb (full/half-duplex)
1000 Mb (full-duplex)
Environmental
Operating temperature 0° C to 85° C (32° F to 185° F)
Operating humidity 20% to 80% (non-condensing)
Operating System Driver Support Windows XP 32-Bit, Windows Vista
32-bit, Windows Vista 64-bit, Win7 32-bit,
Win7 64Bit.
Manageability (examples WOL, PXE..) WOL, PXE 2.1
Management Capabilities Alerting (examples ASF 2.0 AMT…) DASH 1.1/ ASF 2.0
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and
network infrastructure is required.
To Next Page
Loading...
Need help?
General
