Dell OptiPlex XE User Manual

Back to Contents Page
I/O Panel
Dell™OptiPlex™XEServiceManual—Desktop
Removing the I/O Panel
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the front panel.
3. Remove the optical drive.
4. Remove the secondary hard drive.
5. Remove the primary hard drive.
6. Disconnect the I/O panel cable from its connector on the system board.
7. Remove the screws that secure the I/O panel to the chassis.
8. Remove the I/O panel from the computer.
Replacing the I/O Panel
To replace the I/O panel, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.

Dell OptiPlex XE Specifications

General

Brand	Dell
Model	OptiPlex XE
Category	Desktop
Language	English