Steps
1 Align the notch on the solid-state drive with the tab on the solid-state drive slot and slide the solid-state drive into the solid-state drive
slot on the system board.
2 Slide the solid-state bracket on to the solid-state drive on the system board.
3 Replace the screw (M2x2.5) that secures the solid-state drive to the system board.
Next step
1 Install the battery.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
Heat sink
Removing the heat sink
Prerequisites
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
20
Removing and installing components
To Next Page
Loading...
Need help?
General
