Replacing the battery-
connector board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the battery-connector board with the screw
holes on the palm-rest assembly.
2 Replace the screws that secure the battery-connector board to the palm-
rest assembly.
3 Route the antenna cable through the routing guides on the battery-
connector board.
4 Adhere the tapes that secure the antenna cable to the palm-rest
assembly.
Post-requisites
1 Replace the system board.
2 Replace the heat-sink assembly.
3 Replace the I/O board.
4 Follow the procedure from step 3 to step 8 in “Replacing the computer
base”.
5 Follow the procedure from step 4 to step 7 in “Replacing the optical
drive”.
6 Replace the keyboard.
7 Replace the memory modules.
8 Replace the wireless card.
9 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
10 Replace the base cover.
11 Replace the battery.
69
To Next Page
Loading...
Need help?
General
