Removing the display
assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the battery.
2 Remove the base cover.
3 Follow the procedure from step 1 to step 3 in “Removing the hard drive”.
4 Remove the wireless card.
5 Remove the memory modules.
6 Remove the keyboard.
7 Follow the procedure from step 1 to step 4 in “Removing the optical
drive”.
8 Follow the procedure from step 1 to step 6 in “Removing the computer
base”.
9 Remove the I/O board.
10 Remove the heat-sink assembly.
11 Remove the system board.
12 Remove the power-adapter port.
Procedure
1 Note the antenna cable routing and remove the cable from its routing
guides.
73
To Next Page
Loading...
Need help?
General
