To Next Page

To Previous Page

Steps

1. Open the display assembly to a 45-degree angle and place the computer at the edge of a flat table so that the display

assembly can extend below the table.

NOTE: For computers shipped with IR camera configuration, disconnect the display cable and IR camera cable.

2. Peel the adhesive tapes and flip the power button board FFC to access the WWAN cables and the Darwin cables.

3. Peel and remove the WWAN cables and the Darwin cables from the palmrest.

4. Remove the eight (M2.5x2.5) screws that secure the hinges to the palmrest.

5. Remove the display assembly from the palmrest.

NOTE:

The touch display assembly for Precision 7560 is a Hinge-Up Design (HUD) assembly and cannot be further

disassembled once it is removed from the bottom chassis. If any components in the touch display assembly are

malfunctioning and need to be replaced, replace the entire touch display assembly.

Installing the display assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the display assembly and provides a visual representation of the installation procedure.

Removing and installing components

Dell P93F User Manual

Other manuals for Dell P93F