Dell S320 User Manual

134 Troubleshooting Your Projector
Changing the Lamp
CAUTION: Before you begin any of the procedures in this section, follow the
Safety Instructions as described on page 11.
Replace the lamp when the message "Lamp is approaching the end of its
useful life in the operation. Replacement suggested!
www.dell.com/lamps" appears on the screen. If this problem persists after
replacing the lamp, contact Dell™. For more information, see Contacting Dell™on
page 144.
CAUTION: Use an original lamp to ensure safe and optimal working condition
of your projector.
CAUTION: The lamp becomes very hot when in use. Do not attempt to replace
the lamp until the projector has been allowed to cool down for at least
30 minutes.
CAUTION: Do not touch the bulb or the lamp glass at any time. Projector
lamps are very fragile and may shatter if touched. The shattered glass pieces
are sharp and can cause injury.
CAUTION: If the lamp shatters, remove all broken pieces from the projector
and dispose or recycle according to state, local, or federal law. For more
information see www.dell.com/hg.
1 Turn off the projector and disconnect the power cord.
2 Let the projector cool for at least 30 minutes.
3 Loosen the two screws that secure
the lamp cover, and remove the
cover.
4 Loosen the two screws that secure
the lamp.
5 Pull the lamp up by its metal handle.
NOTE: Dell™ may require lamps
replaced under warranty to be
returned to Dell™. Otherwise,
contact your local waste disposal
agency for the address of the
nearest deposit site.
6 Replace with the new lamp.
7 Tighten the two screws that secure the lamp.
8 Replace the lamp cover and tighten the two screws.

Dell S320 Specifications

General

Number of colors	1.073 billion colors
Native aspect ratio	4:3
Projection distance	0.4 - 3.82 m
Projection technology	DLP
Supported aspect ratios	16:9
Contrast ratio (typical)	2200:1
Screen size compatibility	31.45 - 300 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-40 - 37 °
Offset	115 %
Throw ratio	0.62:1
Zoom capability	Yes
Focal length range	- mm
Lamp power	240 W
Light source type	Lamp
Service life of light source	3000 h
Service life of light source (economic mode)	4000 h
Full HD	No
Supported video modes	1080i, 1080p, 480i, 480p, 576i, 576p, 720i
Analog signal format system	NTSC, NTSC 4.43, NTSC J, NTSC M, PAL B, PAL D, PAL G, PAL H, PAL I, PAL M, PAL N, SECAM B, SECAM D, SECAM G, SECAM K, SECAM K1
RMS rated power	5 W
Number of built-in speakers	1
HDMI version	1.4a
Composite video in	0
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
VGA (D-Sub) ports quantity	3
Noise level	35 dB
Noise level (economic mode)	31 dB
Placement	Desktop
Product type	Short throw projector
Product color	White
Market positioning	Short throw
Cable lock slot type	Kensington
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	305 W
Power consumption (PowerSave)	15 W
Storage temperature (T-T)	0 - 60 °C
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	0 - 90 %
Operating relative humidity (H-H)	0 - 80 %

Weight and Dimensions

Depth	220 mm
Width	288 mm
Height	92 mm
Weight	3180 g