29
8 Gas installation
IMPORTANT NOTE
This appliance is supplied for use on NATURAL GAS only and cannot be used on any other
gas without modification.
This appliance is manufactured for conversion to LPG and is supplied with a conversion kit.
The cooker must be installed by a qualified person in accordance with the Gas Safety
(Installation and Use) (Amendment) Regulation 1990 and the relevant building/l.E.E.
Regulations.
The following British Standards should be used as reference when installing this appliance.
BS6172 1990, BS5440 part 2 1989 and BS6891 1988.
Failure to install the appliance correctly could invalidate any manufacturers warranty and
lead to prosecution under the above quoted regulation.
In the UK C.O.R.G.I registered installers are authorised to undertake the installation and
service work in compliance with the above regulations.
Gas connection
The installation of the cooker to Natural Gas or LP Gas must be carried out by a qualified gas
engineer. Installer shall take due account of the provisions of the relevant British Standards
Code of Practice, the Gas Safety Regulations and the Building Standards (Scotland)
(Consolidation) Regulations issued by the Scottish Development Department.
Installation to Natural Gas
Installation to Natural Gas must conform to the Code of Practice, etc. The supply pressure
for Natural Gas is 20 mbar.
To Next Page
Loading...
Need help?
General
