29
This cooker has class “2/1” overheating protection so that it can be installed
next to a cabinet.
The appliance may be installed in a kitchen, Kitchen/diner or a bed sitting room, but
not in a room or space containing a bath or a shower.
The appliance must not be installed in a bed-sitting room of less than 20 m
3
.
The appliance is designed and approved for domestic use only and should not be
installed in a commercial, semi commercial or communal environment.
Your product will not be guaranteed if installed in any of the above environments and
could affect any third party or public liability insurances you may have.
If the cooker is installed adjacent to furniture which is higher than the gas hob cook-
top, a gap of at least 200 mm must be left between the side of the cooker and the fur-
niture.
The furniture walls adjacent to the cooker must be made of material resistant to heat.
The veneered synthetic material and the glue used must be resistant to a temperature
of 90°C in order to avoid ungluing or deformations.
Curtains must not be fitted immediatly behind appliance or within 500 mm of the sides.
It is essential that the cooker is positioned as stated in Fig. 9.1.
The cooker must be installed by a qualified technician and in compliance with
local safety standards.
If the cooker is located on a pedestal it is necessary to provide safety measures to pre-
vent falling out.
To Next Page
Loading...
Need help?
General