WARNING INDICATORS
INDICATOR POSSIBLE CAUSE SOLUTION
FLASHING
Insucientwaterinthetank. Fill the tank with water and/or insert it correctly, pushing it
as far as it will go until it clicks into place�
The tank is not correctly in place� Insert the tank correctly and press as far as it will go�
FLASHING
The grounds container (A14) is full� Empty the grounds container and drip tray, clean and
replace�
Important: When removing the drip tray, the grounds
container must be emptied, even if it contains few grounds�
If this is not done, when you make the next coees, the
grounds container may ll up more than expected and clog
the machine�
After cleaning, the grounds container has
not been replaced�
Remove the drip tray and insert the grounds container�
FLASHING
The grind coarseness is too ne and the
coee is delivered too slowly or not at all�
Repeat coee delivery and turn the grind coarseness dial
(g� 14) one click clockwise towards “7” while the grinder
is in operation�
If after making at least 2 coees delivery is still too slow,
repeat the correction procedure, turning the grinding
dial another click until delivery is correct (see the section
“Adjusting the grinder” on page 11)�
If the problem persists, turn the steam dial to the I position
and let some water run from the cappuccino maker�
FLASHING
The “pre-ground coee” function has been
selected without placing any pre-ground
coee in the funnel�
Place pre-ground coee in the funnel or deselect the
pre-ground function�
RED AND WHITE ALTERNATE
FLASHING
The machine must be descaled� The descaling procedure described in the “Descaling”
section needs to be performed as soon as possible�
FLASHING
Too much coee has been used� Select a milder strength or reduce the quantity of pre-
ground coee, then make the coee again�
FLASHING
The coee beans have run out� Fill the beans container
The pre-ground coee funnel is clogged� Empty the funnel with the help of the handle of the
measuring spoon, as described in the section “Cleaning the
pre-ground coee funnel”�