DeLonghi ECAM 23 User Manual

12
1� Fill the container with coee beans (g� 15)�
2� Place under the coee spouts:
 -1cup,ifyouwanttomake1coee(g.16);
- 2 cups, if you want 2 coees (g� 17)�
3� Lower the spout as close as possible to the cup(s)� A coee
with more crema is obtained in this way (g� 18)�
4� Press the button for delivery of the required coee�
ristrettox1 x2
lungox1 x2
5� Delivery begins and the indicator corresponding to the
selected button comes on on the control panel�
Once the coee has been made, the appliance is ready to be
used again�
Please note:
• While the machine is making coee, delivery can be
interrupted at any moment by pressing one of the
illuminated coee buttons�
• Attheendofdelivery,toincreasethequantityofcoeein
the cup, just press and hold (within 3 seconds) one of the
coee buttons�
Please note:
For hotter coee, see the section “Tips for a hotter coee”�
Important!
• If the coee is delivered in drops, too weak and with
not enough crema or too cold, read the tips in the
“Troubleshooting” section on page 18�
• Indicators may be displayed on the control panel during
use� Their meaning is given in the section “Warning
indicators” on page 17�
Making coee using pre-ground coee
Important!
• Neverplacecoeebeansinthepre-groundcoeefunnel
as this could damage the appliance�
• Neveraddpre-groundcoeewhenthemachineisturned
o or it could spread through
the inside of the appliance and
dirty it� This could damage the
appliance�
• Never use more than 1 level
measure or it could dirty the inside of the appliance or
block the funnel�
Please note:
If you use pre-ground coee, you can only make one cup of
coee at a time�
1� Make sure the appliance is turned on�
2� Turn the coee selection dial anticlockwise as far as it will
go to the position (g� 19)�
3� Make sure the funnel is not blocked, and then add one
level measure of pre-ground coee (g� 20) using the
measure provided (C1)�
4� Place a cup under the coee spouts�
5� Press the required 1 cup ( or ) button�
6� Delivery begins�
MAKING LONG COFFEE
L0NG coee can be made using either coee beans or pre-
ground coee�
Follow the directions above to prepare the machine and press
the LONG button�
MAKING CAPUCCINO AND HOT MILK NOT
FROTHED
Danger of scalding!
Be careful of scalding as steam escapes during preparation of
these drinks�
1� When preparing cappuccino, make the coee in a large
cup;
2� Fill a container (preferably one with a handle to avoid
scalding) with about 100 grams of milk for each
cappuccino� In choosing the size of the container, bear in
mindthatthemilkwilldoubleortripleinvolume;
Please note:
For a richer denser froth, use skimmed or partially
skimmed milk at refrigerator temperature (about 5°C)�
To avoid milk with poor froth or large bubbles, always
clean the cappuccino maker as described in the section
“Cleaning the cappuccino maker after use”�
3� Make sure the cappuccino/hot milk toggle is positioned
downwardsintheCAPPUCCINOposition(g.21);
4� Press the : button: the fading indicator indicates
that the appliance is heating up�
5� Immerse the cappuccino maker in the milk container�
6� After a few seconds, when the indicator ashes,
turn the steam dial to the I position (g� 6)� Steam is
delivered from the cappuccino maker, heating the milk,
giving the milk a creamy frothy appearance and making it
morevoluminous;
7� For a creamier froth, rotate the container with slow
movements in an upward direction� (You should not
Mio caè
short
long

DeLonghi ECAM 23 Specifications

General

Water Tank Capacity	1.8 L
Bean Container Capacity	250 g
Pump Pressure	15 bar
Power	1450 W
Milk Frother	Yes
Grinder	Yes
Adjustable Coffee Spout Height	Yes
Removable Water Tank	Yes
Removable Drip Tray	Yes
Coffee Grounds Container Capacity	14 servings
Voltage	220-240 V
Hot Water Function	Yes
Hot Milk System	Yes
Programmable	Yes
Adjustable Coffee Strength	Yes
Adjustable Coffee Quantity	Yes
Automatic Cleaning	Yes
Automatic Descaling	Yes
Dimensions	238 x 430 x 340 mm