DeLonghi ECAM 23 User Manual

10
AUTOOFF
Auto-o can be set so that the appliance turns o after 15 or 30
minutes, or after 1, 2 or 3 hours�
To re-set Auto-o, proceed as follows:
1� With the appliance turned o but with the main power
switchpressed down, press the button and
hold it down until the indicators on the control panel
come on�
2� Press the button until the indicators corresponding
to the amount of time before the appliance turns o
automatically come on:
15 minutes ECO
30 minutes ECO
1 hour ECO
2 hour ECO
3 hour ECO
3� Press the button to conrm the selection� The
indicators go o�
ENERGY SAVING
Use this function to enable or disable Energy Saving�
When enabled, the function reduces energy consumption in
compliance with EU regulations�
Energy saving mode is active when the ECO indicator is on�
1� With the appliance turned o but with the main power
switch pressed down, press the button and hold it
down until the ECO indicator comes on (g� 8)�
2� To deactivate this function o, press the : button
until the ECO indicator ashes�
3� To re-activate this function, press the : button
again: the ECO indicator should come on�
4� Press the button to conrm the selection� The ECO
indicator goes o�
Please note:
When in energy saving mode, a few seconds may elapse before
the rst coee is delivered as the appliance must heat up
again�
WATER SOFTENER FILTER
Certain models are tted with a water softener lter� If this
is not the case with your model, you are recommended to
purchase one from authorised De’Longhi Service Centres�
Important:
• Keepinacooldryplaceoutofdirectsunlight.
• After opening the packaging, use the lter at once�
• Remove the lter before descaling the machine�
To use the lter correctly, follow the instructions below�
Installing the lter
1� Remove the lter from the packaging�
2� Turn the date indicator disk until the next two months of
use are displayed (g 9)�
Please note:
The lter lasts about two months if the appliance is used
normally� If the coee machine is left unused with the lter
installed, it will last a maximum of three weeks�
3� To activate the lter run tap water into the hole as
indicated in the diagram letting the water run out of the
side openings for at least one minute (g� 10)�
4� Take out the tank from the appliance and ll with water
(g� 1A)�
5� Place the lter in the water tank and submerge it
completely, tilting it to enable the air bubbles to escape
(g� 11)�
6� Insert the lter into the lter housing and press as far as it
will go (g�12)�
7� Close the tank with the lid (g� 13), and then replace the
tank in the machine�
8� Place a container with a minimum capacity of 100 ml
under the cappuccino maker�
9� Turn the steam dial to the I position to deliver hot water�
10� Let the machine dispense hot water for a few seconds
until the ow of water is steady, then turn the steam dial
back to the 0 position�
�
Please note:
Occasionally one delivery of hot water is not enough to install
the lter and the following indicators will come on during
installation:
If this happens repeat the installation procedure from point 9�
The lter is now active and you can use the coee machine�
Removal and replacement of the water softener
lter
After two months (see date indicator disk), or if the appliance
has not been used for 3 weeks, the lter must be removed from
the tank and replaced with a new one� Then the installation
procedure above must be repeated�
MAKING COFFEE
Selecting the coee strength
Turn the selection dial (B10) to set the required coee strength�
Turning it clockwise increases the quantity of coee beans
the appliance will grind and therefore increases the coee
strength�

DeLonghi ECAM 23 Specifications

General

Brand	DeLonghi
Model	ECAM 23
Category	Coffee Maker
Language	English